Evolusion - Stainless Steel Insert .2445

$24.50

Tap here to visit the Evolusion Arrows website.

The Raptor .2445 ID Stainless Steel insert offers maximum FOC where the shaft spine can handle the extra mass upfront.

Break-Off design: 75 to 55 grains.

  • Excellent for increasing the FOC and overall arrow weight of the Raptor 400, 350, 300 and 250 spine shafts.
  • Suits a screw-in point with an OD of 5/16" or 19/64".

Use with the following brands/models of .2445 / .246 ID (6.2 mm) carbon shafts:
Evolusion
 Raptor and Raptor X.
Victory VForce Sport, Gamer and Elite.
Easton 6.2 mm, Hyperspeed and Powerflight.
Black Eagle Outlaw, Zombie Slayer and Carnivore.
GoldTip Hunter, Velocity and Traditional series.

Sold in 12-packs.

INSTALLATION TIPS

Install inserts with any reputable 24 hr set epoxy adhesive. 
We prefer AAE Epoxy for all insert and outsert installation.

If a Loctite adhesive is used, it MUST be an impact resistant formula.
Beware! Cyanoacrylate adhesives set fast - you have limited time to move the insert into place when installing in the carbon shaft. DRY TEST FIT PRIOR!

Don't skimp on the prep! Ensure both the insert AND carbon shaft have be cleaned with isopropyl alcohol.
Don't use methylated spirits, mineral turpentine, brake cleaner, rubbing alcohol or Shellite.

Don't soak the arrow shaft in the isopropyl for an extended period of time - a small amount of isopropyl on a cotton tip is all that is required to clean the internal surface of the shaft.

Use a dry cotton tip to remove any alcohol that has not evaporated. A clean cotton rag and a little isopropyl will sufficiently clean the post of the insert.

Clean both shaft and insert until all factory residue is removed, and you won't go wrong.

Colours of actual products may vary to those displayed on your device. All text and photography is subject to copyright.